MSI Everlife Studio Roswell

MS001 Universal Pressure Sensitive LVT Adhesive is and ultra-low odor, zero calculated VOC adhesive with aggressive tack properties. This light-colored, solvent-free adhesive is made in the USA and contains and antimicrobial system for enhanced resistance to mold and mildew. When used with Vinyl Floor Tile, it provides a tenacious, permanent bond that’s approved for residential and light-commercial environments. This is a 4 gallon pail and each gallon covers approximately 220-260 square feet.

Adhesive/Cutback Sealer a 4 gallon bucket. Each gallon covers approximately 315-360 square feet. This light-colored, high-strength acrylic polymer compound is solvent-free and contains and antimicrobial system for enhanced resistance to mold and mildew.

This acrylic floor preparation Concrete & Floor Primer solution is designed to improve flooring substrates for a better bonding surface before the application of a floor-covering adhesive for installing Vinyl Floor Tile. MSI’s MS003 is suitable for a variety of substrates and can help prevent over absorption of adhesives— resulting in a better bond. Offering zero calculated VOC’s and ultra-low odor, it’s and ideal water-based primer designed and warranted for use only in conjunction with MSI adhesives. This is a 4 gallon pail, each gallon covers approximately 350-400 square feet with 3/8" nap roller and 400-500 square feet with sprayer application.

MS001 Universal Pressure Sensitive LVT Adhesive is and ultra-low odor, zero calculated VOC adhesive with aggressive tack properties. This light-colored, solvent-free adhesive is made in the USA and contains and antimicrobial system for enhanced resistance to mold and mildew. When used with Vinyl Floor Tile, it provides a tenacious, permanent bond that’s approved for residential and light-commercial environments. This is a 1 gallon pail and each gallon covers approximately 220-260 square feet.

94" Large End Caps (also called baby threshold or square nose) are used to fill the gap between the floor and carpet, hearths or against sliding doors. 1.5" x 0.529" x 94".

94" flush stair noses with an eased edge (also called bullnose) are used to finish the end of a step. 2.75" x .75" x 94". A flush square stair nose.

94" t molding are generally used to transition between wood/wood-like and tile floors, sometimes it is used to transition between and existing wood floor as well, or maybe any surface close in height to the new wood/wood-like floor. 1.77" x 0.28” x 94".

94" quarter round are used against cabinets, sometimes against baseboards if you choose to not remove them, and sometimes against other flat vertical surfaces such as some thresholds. 0.64" x 0.75” x 94".

94" Overlap Stairnose, sometimes referred as a bullnose. Used on the outside corner of a stair or step down to finish/trim out the wood, laminate, or vinyl between the riser and the tread. 2.23" x 1.03” x 94".

2-pack, 47.25" stair tread eased edge is used to fully cover the top layer for each stair, eliminating the need for stair nosing. 12" x 1.25” x 47.25".